The WATERGYM BELT is molded out of a high quality, super-soft foam, which is one of the reasons our belt is one of the most comfortable flotation belts on the market today. The inherent nature of foam is that it can be damaged without proper care. So be sure to handle your belt with care and follow these few simple instructions to prolong the life of your belt…
- Rinse with clean, fresh water after each use. Hang flat to dry.
- Do not fold or squish your belt into lockers or tight areas, which can crease or damage the foam.
- Store belts indoors and away from extreme hot or cold weather conditions.
- BE GENTLE WHEN TIGHTENING YOUR BELT. Do not pull and tug on the black elastic webbing so hard that it stresses the foam. It is best to take off your belt, make your sizing adjustment, then put your belt back on. This is especially important when there are multiple users of a single belt (such as in a swim facility). Only do this while out of the water!
- Be careful not to puncture or tear the foam. Check frequently to make sure.
If you accidentally puncture or tear your belt, don’t worry! Our foam can usually be repaired with common super-glue! Here’s how…
- Rinse your belt with fresh water and then let your belt dry out completely for at least a day or two. Make sure all of the moisture is out of your belt before proceeding…
- Apply a generous amount of "super glue" (also known as "crazy glue") to the entire surface area that has separated. Make sure to apply to both surface halves, coating the entire center area all the way out to the edges of the foam.
- Firmly press the two sides of foam together and hold for about 20-30 seconds. Be careful not to get any super-glue on your fingers or they will stick to the belt!
- Test the seal of the foam by gently pulling to see if it adhered. If not, add more super glue and repeat.
- Let the belt dry completely for one or two days before using. Your belt is repaired!
FACILITIES: PLEASE PRINT OUT AND POST WHERE BELTS ARE STORED
